issues with trimming project

When Worx4 X finds a multicam clip, it will trim the clips used in the angles to the length of the multicam clip (plus handles).

I noticed that all angles in your multicam clip, you have used the entirety of 3 compound clips, so their content will not be trimmed.

If Worx4 X were to remove any audio/video from this sequence, but leave the structure as it is (i.e. leave the multicam clip as a multicam clip), then changing angles in the multicam clip would result in the project pointing to media that was offline.

attached.

Can you please attach your fcpxml?

I have a 39 minute edit from a conference. The edit is a 3 camera Multicam.

When I run the XML through W4X, it says the project is 12.5 hours and the optimized will be 12.5 hours with no savings.

Is there some issue with processing multi cams?